aeproject node

Start your local development node

aeproject node

The node command help developers run their local network. The local network contains 3 nodes. To spawn a fully functional network takes couple of minutes. At the end of this command you will be presented with accounts that you can use in your unit tests.

If you are running on Windows environment and it is before Windows 10

  • You need to start manualy your Docker Quickstart Terminal.

  • Optional parameter --windows allows you run AE node and compiler with predefined configuration. It uses docker-compose cli commands and it starts with the default docker machine with IP "192.168.99.100"

aeproject node --windows
  • if docker default machine IP is running on different IP, you can set it by --docker-ip optional parameter. Default IP is "192.168.99.100"

    aeproject node --windows --docker-ip 192.168.99.100

You can stop the node only by typing

aeproject node --stop

Similarly as the start commands you have few option to choose what you want to stop while doing your project.

If you have running instances of the node started from aeproject you could check information about the node with

aeproject node --info

There is optional parameter --v. To specify a specific version of node, you should type

aeproject node --v v5.3.0

Disclaimer

Please note that in rare occurrences you may experience some delay, or even timeout exception while trying to run the node. This usually happens due to new version of the docker images which the docker is trying to pull, or possibly could happen after updating the aeproject verson with new node/compiler version. The files may be large or connection inconsistency may occur. Please try to run docker pull or simply retry to run aeproject node again.